W/4L80E Standalone Swap Wiring Harness Drive by Cable Throttle Body Compatible with DBC LS1 1997-2006 w/ 4L80E 4.8L 5.3L 6.0L Vortec Engines

Fitment:- Fit for 1997-2004 CORVETTES- Fit for 1999-2006 GM TRUCKS- Fit for LS1/LS6 (5.7L) Corvettes and Vortec (4.8L, 5.3L, 6.0L) GM trucks- Fit for drive-by cable applications with LS1 intake manifolds and 4L80E transmissions- Fit for 97-06 W/4L80E 4.8L 5.3L 6.0L GM LS1 Compatible with VORTEC DBC Drive by CableSpecifications:1.The wire harness made of high-quality plastic and copper core, safe to use, and is not easy to be damaged and broken.2.Every product undergoes a quality test before leaving the factory. Professional installation is highly recommended (No Instruction Included).3.100% quality inspection before leaving the factory, saving you money and time.Important Fitment Note:- The Compatibility Is Just For Reference. Please Compare The Details With Your Original Part Before Purchasing.- We provide clear pictures, measurements where possible. Please check as much as possible to make sure the item is the one that you need

• 【Compatibility】- Replace Part Number: LS1 W/4L80E. Wiring Harness Compatible with GM DBC LS1 4.8L 5.3L 6.0L Vortec Engine 1997-2006, W/4L80E Drive by Cable. Compatibility is just for reference, please confirm your OE number.
• 【Improve Performance】- The failure of the automobile transmission wiring harness can cause problems such as poor contact, signal interruption, and short-circuiting. So it should be checked and replaced in time.
• 【Complete Accessories】- With engine and transmission sensor connectors, ALDL connector, ATO Style fuse block, fuel pump relay, switched power ignition relay, performance shift mode wiring, MIL light wiring, P/N Wiring, TCC/ Switch wiring, tach wiring.
• 【Plug and Play】- Easy to install, Plug and play. A sliding grommet seal allows for professional, leak-proof installation. Pay attention to the location of the connectors, make sure all connectors, plugs and wires are inserted correctly.
• 【Premium Quality】- W/4L80E Standalone Swap Wiring Harness is made of high-quality plastic and copper core to provide a great heat protection, safe to use, and is not easy to be damaged and broken.